Peddinghaus PeddiMat Angle Line
Key Specifications
angle leg size max
material thickness max
punching force
hole diameter range
feed accuracy
control
How much does the Peddinghaus PeddiMat Angle Line cost?
Estimated price range
Our best estimate for a cnc punch presse in this class — not a quote from Peddinghaus. Configuration moves it a long way.
Overview
The Peddinghaus PeddiMat Angle Line is listed as a punching line for structural angle, taking legs up to 200 x 200 mm in material up to 20 mm thick with a punching force of up to 110 tons. It is absent from Peddinghaus's current pages, so the listed figures are unconfirmed against the maker.
Hole sizes run from 12 mm – 35 mm, and the table marks that range as tooling dependent, meaning the diameters a machine can punch are whatever its punch and die sets cover inside that span. Feed accuracy is ±0.5 mm. On long bracing angles, where hole pitch accumulates along the length, that is the figure to compare with the fabrication tolerance.
The control is the Peddinghaus PeddiPro and the machine weighs approximately 18,000 kg. The table has no rows for shearing, marking, feed speed or maximum angle length, so whether a given line cuts to length or stamps part numbers has to be established from the machine itself.
Full Specifications
| Parameter | Value |
|---|---|
| Angle Leg Size Max | Up to 200 x 200 mm |
| Material Thickness Max | Up to 20 mm |
| Punching Force | Up to 110 tons |
| Hole Diameter Range | 12 mm – 35 mm (tooling dependent) |
| Feed Accuracy | ±0.5 mm |
| CNC Control | Peddinghaus PeddiPro |
| Machine Weight | Approx. 18,000 kg |
Specifications compiled from manufacturer literature and industry references. Not independently verified against a published spec sheet — confirm with the manufacturer or an authorised dealer before making a purchasing decision.
Strengths & Limitations
Strengths
- Punching force up to 110 tons for angle up to 20 mm thick
- Angle legs up to 200 x 200 mm
- Hole diameters from 12 mm – 35 mm, depending on tooling
- Feed accuracy of ±0.5 mm under the Peddinghaus PeddiPro control
Limitations
- The 12 mm – 35 mm hole range is tooling dependent, so a machine may not have every size
- No shearing, marking or feed speed figures in the table
- Absent from Peddinghaus's current pages; the listed figures are unconfirmed
Best For
Frequently Asked Questions
01
The listed maximum is an angle leg size of up to 200 x 200 mm with material thickness up to 20 mm. Minimum leg size and maximum bar length are not given, so check them for the specific line.
02
Hole diameter is listed as 12 mm – 35 mm and tooling dependent, with a punching force of up to 110 tons. The table does not say how many punches are mounted per leg or whether slotted holes are possible.
03
Feed accuracy is listed at ±0.5 mm. No feed speed is given alongside it, and the table does not state over what length that accuracy is held, so ask for the measuring system details on any machine being considered.
More from Peddinghaus
Peddinghaus FAB-MASTER 8
Peddinghaus FPB-1500
Peddinghaus ABCM 1100
Peddinghaus FPB 1500/1
Peddinghaus AFSC-1100
Peddinghaus BDU-1100/3
Other CNC Punch Presses
TRUMPF TruBend 5085
Finn-Power A5 Punch Press
